The short answer
SaunaBox's Pulse Pro product page gives two answers to two basic questions. It lists 320 LEDs in total in its specifications and 320 LEDs on each wand in its FAQ, and it states both 1,500 W and 1,600 W. The page does not say which figures are correct, and we cannot settle it from the outside.
The two conflicts at a glance
Figures that differ between sections of the SaunaBox Pulse Pro product page , read November 11, 2026
| Specification | Figure A and Where | Figure B and Where | Why It Matters |
|---|---|---|---|
| Red light LED count | 320 in total across the two light panels (Product Specifications; specifications list). | 320 on each wand, which would mean 640 in total (FAQ, What's Included). | One reading has twice the light sources of the other. |
| Power draw | 1,600 W (specifications list; Technical Specifications; the FAQ's cost formula). | 1,500 W (product Q&A on electricity cost). | Affects running cost and how much of a household circuit the sauna uses. |
Each figure is listed with the page section it appeared in on the morning of November 11, 2026, Pacific time, so a reader can find it or see that it has changed. The page also names the product three ways: Pulse PRO, PULSE and The Pulse.
Which numbers are correct?
We do not know, and the page gives a reader no way to tell. Our rule for every brand we cover is to print both figures when a manufacturer's own page conflicts and not to pick one. What can be said from the page itself:
- LED count. Two sections give 320, one of them explicitly as the total. One says 320 per wand. Two dealer listings we saw indexed on the check date also describe a 320-LED light. That is a count of statements, not proof; only SaunaBox or a look at the hardware can confirm it.
- Wattage. Four statements use 1,600 W and one uses 1,500 W. The FAQ's own cost formula says it assumes the listed 1,600 W draw.
Two more figures that need clarification
These are not contradictions, because both statements in each pair can be true at once. They are points the page leaves unexplained.
- Running cost. The page gives two ceilings for a 60-minute session: under $0.11 in Product Specifications and under about $0.25 in its electricity Q&A. Its FAQ separately estimates about $0.20 for a 40-minute preheat and session at the full 1,600 W. The lowest ceiling would need an average draw far below the rated wattage, as the arithmetic below shows, and the page publishes no measured consumption.
- Reference price. Two struck-through prices, $900 and $749, appear beside the $649 sale price shown on the check date. The page does not say which is the regular price.
What the page's own numbers imply
The FAQ publishes its inputs: 1.6 kW, 40 minutes (20 of preheating and a 20-minute session) and $0.1831 per kWh, for about $0.20. That calculation checks out. Applying the same published rate to the page's other statements gives the following. These are our calculations from SaunaBox's inputs, not measurements.
Session cost at the page's stated rate of $0.1831 per kWh, assuming continuous draw at the rated wattage
| Scenario | Energy | Cost |
|---|---|---|
| 1,600 W for 40 minutes (the FAQ's case) | 1.07 kWh | $0.20 |
| 1,600 W for 60 minutes | 1.60 kWh | $0.29 |
| 1,500 W for 60 minutes | 1.50 kWh | $0.27 |
| What an $0.11 hour would require | 0.60 kWh | An average draw of about 600 W |
Heating panels can cycle below their rated draw once a sauna reaches temperature, so a real session may cost less than the continuous-draw figures. An average of about 600 W across an hour that includes warm-up would be a large reduction from a 1,600 W rating, and the page publishes no measured consumption to support it. The differences are a few cents per session. The point is a narrow one: the page's lowest cost ceiling is not explained by any figure it publishes.
The wattage question has one practical edge. At a nominal 120 V, 1,500 W is 12.5 A and 1,600 W is about 13.3 A. Either figure uses most of a standard 15 A household circuit, so the sauna should not share its circuit with other heavy loads.
Could these be two versions of the product?
Possibly. A revised model with a different light panel or heater set would explain two LED counts and two wattages. The page text names no versions. Image file names on the page include v1 and v2 labels, which may point to a revision, but the page does not say which specifications belong to which unit or which one ships today.
What the page states consistently
- A maximum temperature of up to 160°F, repeated throughout the page. This is SaunaBox's figure; we have not measured it.
- Red light irradiance of 63.19 mW/cm², stated once and qualified as measured at the surface.
- A 1-year limited warranty.
- Six infrared heating panels and a 110 V power requirement.
- Its FAQ shows the formula behind its electricity estimate, which lets a reader check it.
What the irradiance figure can and cannot show is covered in our review of SaunaBox red light claims.
Questions to settle before you buy
- How many LEDs does the unit shipping today have in total, and how many per panel?
- What wattage is printed on the unit's rating label?
- Has a session's energy use been measured in kWh, and what was the result?
- Is there more than one version of the Pulse Pro, and which one will I receive?
- Which struck-through price is the regular price?
The rating label on the delivered unit is the quickest check on wattage. The return policy requires an unused product, so read the label before the first session. SaunaBox's other published terms are in our document-based SaunaBox review.
Bottom line
The Pulse Pro page contradicts itself on two specifications, LED count and wattage, and gives running-cost ceilings it does not reconcile. None of this changes what the product is: a plug-in tent sauna with a red light panel, sold for $649 on the check date. It does mean a buyer should not rely on the published LED count or wattage without confirmation, and should get both from SaunaBox in writing if either matters to the purchase.
Sources and verification
Every source below was read on November 11, 2026.
- SaunaBox, Pulse Pro product page. Every figure in this article: LED counts, wattage, electricity cost statements, temperature, irradiance, warranty, prices.
- SaunaBox, Return and Refund Policy. Unused condition for returns.
Method and limits
This is a document review. We read the pages listed above on the morning of November 11, 2026, Pacific time, and report what they said then, naming the page section each figure came from so a reader can find it or see that it has changed. We did not buy or test a SaunaBox product, and we did not contact SaunaBox for comment. SaunaBox revises its pages (its help center return article showed an update within the week before our check), so wording may have changed since; the linked page controls. Where two SaunaBox pages disagree, we print both and do not choose between them. Statements that we did not find something describe our reading on that date and are not proof of absence. Nothing here states or implies that SaunaBox acts in bad faith or that its products are unsafe. Links to saunabox.com carry rel="nofollow" because of the competitive relationship disclosed above. If SaunaBox publishes a correction or sends one, we will update this page and log the change. The session cost table is our arithmetic from the inputs SaunaBox publishes; it is not a measurement of the product.
More SaunaBox record checks
This article is one of eight document reviews of SaunaBox's published terms and claims. Our earlier record check of the complaint history is here: SaunaBox Complaints (2026). The other seven:
- SaunaBox Return Policy: The $500 Fee and "Unused" Requirement Buyers Should Know
- SaunaBox Warranty Gaps: Why Repairs Could Still Cost You
- SaunaBox Arrived Damaged? The Shipping Policy Buyers Should Read First
- SaunaBox's FDA-Registered Manufacturing Claim: What It Actually Proves
- SaunaBox Red-Light Therapy Claims: What Do the Published Numbers Actually Tell Buyers?
- SaunaBox's Detox and Hormone Claims: Where Is the Product-Specific Evidence?
-
SaunaBox Review: Return Restrictions, Warranty Exclusions and Conflicting Specs
FAQs
How many LEDs does the SaunaBox Pulse Pro have?
SaunaBox's product page gives two answers. Its specifications say 320 LEDs in total across two light panels, and its FAQ says 320 LEDs on each wand, which would be 640 in total. The page did not resolve the difference when read on November 11, 2026.
Is the SaunaBox Pulse Pro 1500W or 1600W?
The product page states both. Its specifications and its FAQ cost formula use 1,600 W, and its product Q&A on electricity cost says the sauna uses only 1,500 W. The rating label on the unit is the way to confirm.
How much does a SaunaBox Pulse Pro session cost in electricity?
SaunaBox's page gives under $0.11 and under about $0.25 for a 60-minute session, and about $0.20 for a 40-minute preheat and session. At the page's own rate of $0.1831 per kWh, continuous draw at 1,600 W for 60 minutes works out to about $0.29.
What is the maximum temperature of the SaunaBox Pulse Pro?
SaunaBox states up to 160°F, consistently across its product page. That is a manufacturer figure; homesauna.com has not measured it.
Are there two versions of the SaunaBox Pulse Pro?
The product page text names no versions. Image file names on the page include v1 and v2 labels, but the page does not say whether its conflicting specifications belong to different versions.